This instruction show you guide on how to solve Deutz EMR3 Engine power out error 74/923 error.
Error Description ENGINE POWER OUT
Output with PWM signal of the engine power: the current drain measured by ECU is out of the target range or the maximum permissible temperature of the ECU component to control the
output is exceeded.
Related Contents:
Error Codes
DEUTZ-Errorcode: 74
BlinkCode (short-long-short): 5 – 5 – 5
SPN: 923
Possible FMI:
3: Voltage to high or short circuit to +Ubatt
4: Voltage to low or short circuit to -Ubatt
5: current to low or broken wire
2: data stream is defective
Error Detection
Error lamp shows permanent light. Entry in error memory.
Possible reason for error
Engine Power output: cable break or short circuit, output defective, connection cable damaged
Take actions for error repair
Check cabling, sensor defect, check sensor and if necessary replace it, check connection cable and if necessary repair or replace it
Other Error Properties
System reaction: Warning, shutoff output
Behaviour error lamp: permanent light
Selfhealing: no
Signal Priority: 1
Measurement @ errortime: shut off value
