Here is the instruction show you guide on how to replace engine oil filter for MANITOU MT6034.
Related Contents:
2026 Manitou I.V Interactive View Diagnostic Kit Software
Procedures:
Change the engine oil and filter using the following procedure:
1 With the engine warm, remove the crankcase drain plug located on the left side of the engine oil pan.
IMPORTANT: DO NOT discharge oil onto ground.
Catch and dispose of per local waste disposal regulations.
2 The engine oil filter should be changed at every oil change interval. Using a suitable filter wrench, remove and discard the filter.
IMPORTANT: Filtration of oils is critical to proper lubrication. Always change filter with every oil
change. Use only genuine OEM engine replacement filters.
3 Apply a thin coat of clean engine oil to the sealing gasket of the new oil filter.
4 Wipe the filter sealing surface on the engine with a clean cloth.
5 Turn new oil filter on by hand until filter contacts the sealing surface then turn the filter an additional 3/4 turn.
6 Clean and re-install the drain plug.
7 Re-fill the crankcase with new oil. Follow specifications in the Lubrication chapter for type and viscosity of new oil.
NOTE: The oil capacity listed is approximate.
Always verify oil level with the engine oil dipstick.
8 After new oil has been added, run the engine at idle
speed until the oil pressure lamp is off. Check for leaks at the filter and drain plug.
9 Verfy the oil level is at the “Full” mark on the engine oil dipstick.
IMPORTANT: Low engine oil level and over full engine oil levels can cause engine damage.
